Re: From GameStop POS Magnum Opus to Razor Cola in 1/64
Posted: Tue Jan 08, 2019 9:01 pm
On to the next step
Looking at the Magnumopus,
it was obvious to me that the lack of the vents
stuck out like a sore thumb
Since I already chopped up a Greenlight V-8
looking at the vent I knew what I needed to do
So I marked it out, and with my jeweler's saw I cut it out
here I was sizing it up trying to decide the best course of action
Here I marked it out in black as to what parts to remove to make the fit
here the vent is fitted
here are the un-modified Magnumopus and the WIP Razor Cola side by side
as of this date.....
this is where I am now
Looking at the Magnumopus,
it was obvious to me that the lack of the vents
stuck out like a sore thumb
Since I already chopped up a Greenlight V-8
looking at the vent I knew what I needed to do
So I marked it out, and with my jeweler's saw I cut it out
here I was sizing it up trying to decide the best course of action
Here I marked it out in black as to what parts to remove to make the fit
here the vent is fitted
here are the un-modified Magnumopus and the WIP Razor Cola side by side
as of this date.....
this is where I am now